This is a kit and is not ready to weld. The tubing comes straight cut Not coped. This kit requires trimmed and fit, unless ordering a tack and fit (not available on all cages).
This is an 8 point, family cage kit for early Ford Broncos, 1966-1977. The tubes are made from 2 inch .120 wall mild steel tubing and fit hard or soft tops. These cages clear stock windshield wiper motors, glove box door will open far enough to get your hand inside, and unlike other cages,the front bars kick forward under the dash for better clearance, making it easy to get in and out of the door opening.Tall Man Option: Normally recommended for anyone over 6 foot or if you just like the look of it better. Your cage will be the same despite some small modifications. The bars have additional bends in them to add headroom but will not add any height to your cage. The two middle shoulder bars are bent upwards about 1/2 - 3/4". The other bars will kick outward to give better headroom.
NOTE: Shipping is not free. These parts ship by truck freight which has rates from varying from $250 to $350 to a commercial or business location depending on what state you are in. We can also ship to a residential location but freight company will charge an additional $20 to $75. You can call or email us before you make an order to get a shipping quote. We will call or email you within 1 business day after you make an order to confirm the shipping cost with you. Your order will not ship until the shipping cost has been confirmed. Farms, Military Bases, Home Based Businesses, Schools, Construction sites are not Considered businesses! We can ship to the nearest Freight Terminal and you can pick it up there as well.
Tack and Fit: We now offer our kits fully fitted and tack welded in our shop jig. Floor plates are welded on, everything is aligned, tacked in place and marked. Then tack welds are broken and shrink wrapped to be shipped to you. It saves you a lot of money in shipping compared to fully welded and the setup time is very fast and simple for a do it yourself install . Simply unwrap, stand main hoops upright, and put the spreader in place according to the numbering system. Square the parts up and away you go. Your new cage will be finished in no time! This option is an additional $145.00.
Fully Welded: Adding this option to a cage kit means that we will weld the tubes together and the floor plates on before shipping it to you. This option is currently available for Ford Bronco cage kits only. Take in mind that the shipping cost will go up and will be much pricier when choosing this option since cage will ship on a pallet.
See a better deal from another vendor? Let us know. We try to meet or beat prices on all of our cage kits.